Page tree
Skip to end of metadata
Go to start of metadata

Stratigraphic Modeling | Add Interval

The "Add Interval" operation is used to determine the starting and ending points of the intervals on the boreholes. By entering the process, the beginning and then the endpoint of the first interval should be displayed on the borehole.

After the interval start and end points are selected on the borehole, the Interval Name should be selected from the Interval Selection window that opens.

The intervals defined in the Project/Properties/Seam Definitions tab are listed in the Interval Name line. For this reason, interval definitions must be made before selecting the interval points.

OptionDescription
Borehole NameThe name of the selected borehole is displayed on the graphic screen.
Group NameGroup information for the intervals defined in the Project/Properties/Seam Definitions tab is listed.
Interval NameIntervals under the selected group defined in the Project/Properties/Seam Definitions tab are listed.
StartIt is the depth information of the starting point of the interval.
EndIt is the depth information of the ending point of the interval.

Before the Add Interval process, the "Angle.csv" file must be imported to the project. If the angle file is not imported, surface creation from the interval points will not be possible.

  • No labels