Page tree
Skip to end of metadata
Go to start of metadata

Block Inside Solid Model

Block Inside Solid Model operation is used to block an existing solid model. 

OptionDescription
Create Block

Maximum X Size: Maximum size of the block to be created on X axis.

Maximum Y Size: Maximum size of the block to be created on Y axis.

Maximum Z Size: Maximum size of the block to be created on Z axis.

Maximum block size to be determined and block parameters in various sizes allow for the operation to be carried out with non-blocked volume being the minimum.

X Angle: Angle that block to be created makes with X axis.

Y Angle: Angle that block to be created makes with Y axis.

Z Angle: Angle that block to be created makes with Z axis.

It allows for blocks to deviate from the horizontal axis in entered angle value and become inclined. If desired, blocks can be given inclines according to geological status of the area or created solid model, and lost solid model volume amount that cannot be blocked can be minimized. When block angles are "0", all blocks are created perpendicular to "z" axis.

Lower Block Coefficient: It shows the half number of maximum block dimension entered. Calculated result will be the minimum block dimension.

Maximum block size: If 10*10*10;

  • Lower block coefficient: Minimum block size for 1: 5*5*5
  • Lower block coefficient: Minimum block size for 2: will be 2.5*2.5*2.5.
Output LayerLayer: It is the name of the layer, upon which the block model will be saved. Created layer can be seen under Blocks tab under Catalog.

 

 

 Video
 

  • No labels