Page tree

Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Comment: Migrated to Confluence 5.3

Create Solid Model Between Elevations

Section
Column
width60%
Info

Create Solid Model Between Elevations operation is used to create solid models on surface according to maximum and minimum elevations. 

On Surface option should be active to create only the upper part on surface of the solid model to be created according to the specified elevation values. If the operation is carried out when it is passive; outer surface of the XY plane of solid model surface shall be taken into account. 

Info
iconfalse
OptionDescription
Output

Ceiling Elevation: Ceiling elevation of the solid model to be created. 

Base Elevation: Base elevation of the solid model to be created. 

On Surface: This option is used in order to only create the upper parts of the surface of the solid model to be created.

Active Project LayersLayer:It is the name of the layer, upon which the solid model will be saved. Created layer can be observed in Solid Models tab under Catalog.
Column
width40%